User Manual
4-16 Bulletin 283 Programmable Parameters
➊ Not available with the Bulletin 283A.
User I/O Group
➊ Not available with the Bulletin 283A.
Warning Status
This parameter warns the user of a condition,
without faulting
Parameter Number 62
Access Rule GET
Data Type WORD
Group Starter Protection Setup
Units -
MinimumValue 0
Maximum Value 65535
Default Value 0
Bit
Warning
1514131211109876543210
X reserved
X reserved
X Phase Loss
X reserved
X reserved
X Control Power
XIO Warning
X reserved
X Phase Imbalance
X DeviceNet
➊
X reserved
X reserved
X reserved
X Har d w a r e
X reserved
X reserved
Off-to-On Delay
This parameter allows the
installer to program a time
duration before an input is
reported “ON”
Parameter Number 30
➊
Access Rule GET/SET
Data Type UINT
Group User I/O
Units ms
Minimum Value 0
Maximum Value 65.000
Default Value 0