User Manual

Publication 2755-2.37 – August 1996

   

(Catalog Number 2755-NC16 Series B)

The Gun Adapter allows you to connect Allen-Bradley hand-held

scanners to the Enhanced Decoders (Catalog No. 2755-DD1, -DS1).

The adapter has two connectors:

• 15-pin D connector plugs into the decoder

• 9-pin D connector accepts the connector of the hand-held scanner

We recommend that you use the Gun Adapter whenever you need to:

• Use an Enhanced Decoder for both attended and unattended

applications.

• Use a hand-held scanner as part of a DH485 network.

• Use discrete outputs as part of an attended application.

The following shows a typical application using a hand-held scanner

(Catalog No. 2755-HUG-4).

Gun Adapter

Installation Instructions

Applications

PAGE 1
Installation Instructions (Catalog Number 2755-NC16 Series B) Overview The Gun Adapter allows you to connect Allen-Bradley hand-held scanners to the Enhanced Decoders (Catalog No. 2755-DD1, -DS1).
PAGE 2
Bulletin 2755 Gun Adapter Equipment Connections To install the Gun Adapter: 1. Make sure power to the decoder is turned off. 2. Attach the 15-pin Gun Adapter connector to the scanner connector on the decoder. Secure connector with hold-down screws. 3. Attach the scanner cable to the 9-pin Gun Adapter connector. Secure the connector with the hold-down screws. 4. Apply power to the decoder. 5. Configure the decoder for operation with the hand-held scanner as described below.