Owner manual

4–4 Installing the Scanner
The Mounting Bracket (Catalog No. 2755-NM6) allows mounting on
flat surfaces. The scanner is supplied with three #10-32 screws (
1
/
2
inch, 12.7 mm long) for mounting. Two sets of mounting holes
allow you to mount the scanner to the bracket as shown below or
turned 90_. The Mounting Bracket Kit (Catalog No. 2755-NM42)
provides additional flexibility.
If creating your own mounting bracket, make holes large enough to
prevent binding and damage to the internal threads of the scanner.
The bracket should be in full contact with the scanner bosses to
conduct heat away from scanner.
Figure 4.3
Mounting Bracket
Three #10–32 screws
(1/2 inch, 12.7 mm long)
are provided with scanner
Mounting Bracket Kit
(Catalog No. 2755-NM42)
Threaded Hole For Mounting Bracket Kit
Mounting Bracket
(Catalog No. 2755-NM6)
3.7 in
84 mm
5.2 in
133 mm
4.5 in
1 14 mm
2.1 in
53 mm
0.3 inn
8 mm
1.3 in
33 mm
1.3 in
33 mm
Mounting Bracket
Dimensions (Nominal)
Note: When using the Mounting Bracket Kit,
screw threaded shaft into hole in the
mounting bracket. Make sure that threaded
shaft does not contact the scanner. Tighten
jam nut.
0.29 in
7.37 mm
➀
➀
➀
➁
➁
➁
➀
➁
Use these holes for mounting scanner using Mounting
Bracket Kit.
7/16–20 UNF–2B
Captive W asher
Note: The scanner has three threaded
holes for mounting screws. The
direction of the scan line is fixed
relative to the pattern of the mounting
holes.
Scan Line
Holes ➀
Scan Line
Holes ➁
Use these holes for mounting scanner on flat surface.
Mounting Bracket