Owner manual

Index
I–1
A
Accessories, 2–6
Autosense Mode, 2–2
disable, 5–7
enable, 5–7
installing autostand, C–1
B
Bar Code Test Symbols, A–1
Beep, 3–7
Beeper Operation, 5–4
C
Cables
scanner interface, 4-2
wedge interface, 2–6, 4-4
Capture Count, 5–5
Codabar
disable, 7–14
enable, 7–14
maximum length, 7–15
minimum length, 7–15
start/stop characters, 7–14
Code 128
disable, 7–13
enable, 7–13
maximum length, 7–13
minimum length, 7–13
Code 39
enable, 7–2
maximum length, 7–4
minimum length, 7–4
modulo 43 check character, 7–3
start/stop characters, 7–3
Code Identifier, 6–5
Continuous Full Power, 5–3, 8–1
D
Digit Selection Symbols, B–1
E
EAN/JAN
check digit, 7–9
disable, 7–8
enable with or without
supplements, 7–8
number system digit, 7–9
Enabling Wedge Mode, 4–6
F
Factory Default Settings, 4–10
G
General Setup Parameters, 2–3, 5–1
autosense mode, 5–7
beeper operation, 5–4
capture count, 5–5
power consumption, 5–3
spotter beam, 5–6
system status, 5–1
Good Read Indicator, 3–2