Owner manual

Setup Instructions
Chapter 4
4–11
Table 4.A (continued)
Scanner Default Settings
Message Format
Parameter
Options Default
Prefix None, STX, or SOH None
Suffix None, ETX, CR, LF, HT, or
CR and LF
None
Scanner Identifier Disable or a number (01- 99) Disable
Code Identifier Disable or Enable Disable
Preamble None or 1-4 characters None
Postamble None or 1-4 characters None
Intercharacter Delay User Defined Delay (in msec) or
No Intercharacter Delay
No Intercharacter Delay
Symbologies
Code
Options Default
Code 39 Disable
Enable Standard Code 39
Enable Full ASCII Code 39
Enable Standard Code 39
Enable or Disable Modulo 43
Check Character
Disable
Enable or Disable Transmission
of Start/Stop Character
Disable
Minimum Length 1
Maximum Length 32
UPC (A and E) Disable
Enable with 2 or 5 digit supplements
Enable without 2 or 5 Digit Supplements
Enable without 2 or 5
Digit Supplements
Enable/Disable Expanded UPC-E Disable
Enable/Disable Transmission
of Number System Chararacter
Enable
Enable/Disable Transmission
of Check Digit
Enable
Enable/Disable UPC to EAN Translation Disable