User Manual

4–10 Installing the Decoder
Publication 2755-833
Note: For best performance, enable only those symbologies you
intend to read. You can find additional information on selecting
symbologies in Chapter 6.
Configure Scanner(s)
Once all your symbology selections have been made, press ESC to
activate the command line at the bottom of the screen. Press ENTER
to select the highlighted “Next Page”.
The Scanner Control screen will appear.
While your actual operation will vary depending on your application,
you will want to follow the same basic steps during initial scanner
setup. Those steps include:
1. Select the scanner based on the narrow element width (the
narrowest bar or space) and desired reading distance
Refer to Bar Code Site Survey (Pub. No. 2755-939) to verify all
important aspects of your own application. Consult the scanner’s
Product Data Sheet or User Manual for read ranges.