User Manual

Decoder Configuration AddressesA–14
Publication 2755-833
Where i ranges from 1 to 16. The decoder shall return status 10H for
references to 1000H–103FH.
Host Message No Read Replacement Strings 2000H–21B9H
PCCC Address Configuration Parameter
Number of
Bytes
Acceptable Values
(Default in bold)
2000H+i*1AH Search Fail String Length
Search Fail String
1
24
0–24 0 = Empty
up to 24 characters
2019H+i*1AH Reserved 1 1
Where i ranges from 1 to 16. The decoder shall return status 10H for
references to 2000H–2019H.
Extended Count Values D800H–DA03H
PCCC Address Configuration Parameter Number of Bytes
Acceptable Values
(Default in bold)
D800H+i*4 Extended Count Value n 4 0 to 999999
Where i ranges from 1 to 128. The decoder shall return status code
10H for references to addresses D800H–D803H.
Extended Match Data 8000H–A03FH
Writes to address 8000 will be interpreted as Autoload. The data
attached to the write must follow the byte order listed in the
following table. The data will be inserted in the next available
autoload position, searching first the primary and then the extended
data table. That entry will be marked as “Match Entry”. If no
entries are available in either table, a code 02 (memory not available)
will be returned. Writes to any location other than 8000 will return
of code 10, and the write request will be ignored.
PCCC Address Configuration Parameter
Number of
Bytes
Acceptable Values
(Default in bold)
8000H Source 1 1 = Scanner A
2 = Scanner B
symbology 1 0 = Code 39
1 = Interleaved 2–of–5
2 = Codabar
3 = UPC–A
4 = UPC–E
5 = EAN–8
6 = EAN–13
7 = Code 128
8 = Pharma–Code
Match pattern – Length
Match pattern – String
1
32
0–32, 0 = Empty
up to 32 characters