User Manual

Decoder Configuration Addresses A–11
Publication 2755-833
Address Command
0662H
Hold output 3 closed
➀
0663H
Hold output 4 closed
➀
0664H
Hold output 5 closed
➀
0665H
Hold output 6 closed
➀
0666H
Hold output 7 closed
➀
0667H
Hold output 8 closed
➀
0668H Start Scanner B Trigger
0669H Stop Scanner B Trigger
Pharma–Code Configuration 0700H–0725H
The decoder shall use the existing ’set match table symbology type’
command with a value of 9 to set the match table symbology type to
PHARMA.
The table below shows the mapping between the PCCC Host
Commands and the parameters described in the P
HARMA–CODE
CONFIGURATION PARAMETERS section.
PCCC Address Configuration Parameter
Number of
Bytes
Acceptable Values
(Default in bold)
700H enable Pharma–Code 1 0 = No
1 = Yes
701H decode direction 1 0 = Forward
1 = Reverse
2 = Forward A
Reverse B
3 = Reverse A
Forward B
702H quiet zone ratio 1 4 – 10, 5 = Default, 0 = Use Default
703H space tolerance 1 0 = Ignore
5 to 40, 15
704H bar tolerance 1 0 = Ignore
5 to 40, 15
705H minimum number of bars 1 3 to 12, 5
706H wide to narrow bar ratio 1 0 = Midrange
2 to 4
707H code verification list entry 1 2 0 = none
7 to 8190
709H to 725H code verification list entry 2 through 16 2 bytes per
entry
0 = none
7 to 8190
➀ The AUX port supports a terminal for either configuring the decoder or for ma
n
entry. For information on use of the AUX port for manual data entry, consult Ch
a