User Manual

Chapter 5
Installing the Decoder
5–8
!
WARNING: If you are using output modules with voltages
exceeding 30 volts RMS or 42.4 volts peak / DC, the wiring to all
modules MUST be routed through the round knockouts into
conduit. The slot on the back of the chassis should only be used
if all modules are used with voltages below 30 volts RMS or 42.4
volts peak / DC.
6) Install module access cover.
Figure 5.6
Module Connections
Module #3
_
+
Module #4
_
+
Module #8
_
+
Module #7
_
+
Module #6
_
+
Module #5
_
+
MODULES
1
2 3456
7
8
CONNECTOR
BLOCKS
NOTE POLARITY
Module #1
_
+
Module #2
_
+