User Manual

A–B
B
Appendix
B–1
Default Parameters of Decoder
The following table lists the factory set default parameters of the
decoder.
Type Default Parameters
Message Format
Send Bar Code Data: Yes
Send Package Count: No
Send Bar Code Type: No
Send Source Identifier: No
Send Header Message: No
Send No–Read Message: No
Expand UPC–E: Yes
Source Identifier: None
Label Delimiter: None
Start Character: None
End Message: CRLF
Transmission Check: None
Header Message: None
No–Read Message: None
Code 39 Check Character: No Send:No
I 2–of–5 Check Character: No Send:No
Codabar Check Character: No Send:No
Host Communication Parameters
Baud rate: 9600
Bits/Char: 8 Data, 1 Stop
Parity: None
ACK Character: None
NAK Character: None
Start Scan Character: None
Stop Scan Character: None
Large Buffer: No
Response Mode: End Of Trigger
Host Protocol: RS–232
Device Address: 01
Package Detect Input
Filter: No
Sense: Lo = Package
Bar Code Type
Code 39: Enabled
Interleaved. 2–of 5: Disabled
Code 128: Disabled
Codabar: Disabled
UPC–A: Disabled
UPC–E: Disabled
EAN–8: Disabled
EAN–13: Disabled
Bar Code Lengths
Code 39: 00, 00, 00, 00, 00, 00, 00, 00
Interleaved. 2–of 5: 00, 00, 00, 00, 00, 00, 00, 00
Code 128: 00, 00, 00, 00, 00, 00, 00, 00
Codabar: 00, 00, 00, 00, 00, 00, 00, 00