Manual

Scanner Configuration (for AdaptaScan Pass Through Cable)2-2
Publication 2755-6.5
Scan These Symbols First
Scan all three of these labels in sequence to set the scanner to the default
settings for use with an AdaptaScan Pass Through Cable.
Scan this Symbol First
then
Set Scanner for AdaptaScan Pass Through Cable Operation
Important: You must then scan the following label to enable the
AdaptaScan Pass Through Communications.
Enable AdaptaScan Pass Through Cable Communications
Also scan the ENABLE ADAPTASCAN PASS THROUGH CABLE
COMMUNICATION bar code to change the configuration from Synapse
communication to the AdaptaScan Pass Through configuration.
When AdaptaScan Pass Through communications is enabled, scan the
appropriate bar codes to configure the scanner. Then, scan the
appropriate bar codes to configure the AdaptaScan Pass Through cable.