User guide
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Installing Your Hardware
- Important Notes on Scanner Systems
- 1. Unpacking the Equipment
- 2. Setting the Address of the Base/Charger Unit
- 3. Connecting the Host Cable to the Base/Charger Unit
- 4. Mounting the Base/Charger Unit
- 5. Mounting the Power Supply
- 6. Connecting the Power Supply to the Base/Charger Unit and Power Receptacle
- 7. Connecting the Host Cable to the Host Device
- 8. Charging the Battery
- 9. Pairing the Scanner to the Base/Charger Unit
- 3 - Configuring Your Scanner
- 4 - Scanner Operation
- 5 - Maintenance and Troubleshooting
- A - Specifications
- B - Cable Pinouts
- C - Advanced Data Formatting
- Glossary
- Index
- Test Symbols
- Back Cover
Maintenance and Troubleshooting 5–19
Publication 2755-6.3
Beep During Code 39 Scan and Store
This Response Indicates
1 Beep (high–low tone)
New Code 39 data was entered into the
buffer.
3 Beeps (long high tone) Code 39 buffer is full.
1 Beep (low–high–low tone)
Attempt to transmit or clear an empty buffer
occurred. When the Code 39 buffer was
empty, the base station read a command to
clear or to transmit a Code 39 buffer.
2 Beeps (long high tone) Error in data transmission.
1 Beep (low–high tone) Buffer data transmission successful.
Contacting Allen-Bradley Global Technical Services
If you should require assistance or need additional information on
operating the scanners, contact Allen-Bradley Global Technical
Services (GTS) at (216) 646-6800.