User guide
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Installing Your Hardware
- Important Notes on Scanner Systems
- 1. Unpacking the Equipment
- 2. Setting the Address of the Base/Charger Unit
- 3. Connecting the Host Cable to the Base/Charger Unit
- 4. Mounting the Base/Charger Unit
- 5. Mounting the Power Supply
- 6. Connecting the Power Supply to the Base/Charger Unit and Power Receptacle
- 7. Connecting the Host Cable to the Host Device
- 8. Charging the Battery
- 9. Pairing the Scanner to the Base/Charger Unit
- 3 - Configuring Your Scanner
- 4 - Scanner Operation
- 5 - Maintenance and Troubleshooting
- A - Specifications
- B - Cable Pinouts
- C - Advanced Data Formatting
- Glossary
- Index
- Test Symbols
- Back Cover
5–10 Maintenance and Troubleshooting
Publication 2755-6.3
!
ATTENTION: Perform the conditioning cycle when
the battery is new or shows decreased life.
Conditioning batteries more often will shorten battery
life.
If conditioning the battery is not successful as indicated by the
flashing REJECTED indicator on the battery charger, your battery
needs replacement. Contact your local Allen-Bradley distributor for
ordering a new battery.
Changing the Battery Pack in the Scanner Gun
1. Locate the handle release button on the scanner.
Battery Pack
Handle Release Button
2. Press in the handle release button below the outer housing with a
probe.