User guide
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Installing Your Hardware
- Important Notes on Scanner Systems
- 1. Unpacking the Equipment
- 2. Setting the Address of the Base/Charger Unit
- 3. Connecting the Host Cable to the Base/Charger Unit
- 4. Mounting the Base/Charger Unit
- 5. Mounting the Power Supply
- 6. Connecting the Power Supply to the Base/Charger Unit and Power Receptacle
- 7. Connecting the Host Cable to the Host Device
- 8. Charging the Battery
- 9. Pairing the Scanner to the Base/Charger Unit
- 3 - Configuring Your Scanner
- 4 - Scanner Operation
- 5 - Maintenance and Troubleshooting
- A - Specifications
- B - Cable Pinouts
- C - Advanced Data Formatting
- Glossary
- Index
- Test Symbols
- Back Cover
4–2 Scanner Operation
Publication 2755-6.3
Scanning Bar Codes
To scan a bar code with either a standard range or long range
scanner:
1. Make sure the bar code symbol is within the proper scanning
range. Refer to page 1–6 for scanning ranges.
2. Hold the scanner at an angle to the bar code symbol. If you hold
the scanner directly over the bar code symbol, light can bounce
back into the scan window and prevent a successful scan.
3. Aim and press the trigger. For the standard range scanner, make
sure the scan beam crosses the entire width of the bar code
symbol.
Correct Incorrect
012345
012345