User guide
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Installing Your Hardware
- Important Notes on Scanner Systems
- 1. Unpacking the Equipment
- 2. Setting the Address of the Base/Charger Unit
- 3. Connecting the Host Cable to the Base/Charger Unit
- 4. Mounting the Base/Charger Unit
- 5. Mounting the Power Supply
- 6. Connecting the Power Supply to the Base/Charger Unit and Power Receptacle
- 7. Connecting the Host Cable to the Host Device
- 8. Charging the Battery
- 9. Pairing the Scanner to the Base/Charger Unit
- 3 - Configuring Your Scanner
- 4 - Scanner Operation
- 5 - Maintenance and Troubleshooting
- A - Specifications
- B - Cable Pinouts
- C - Advanced Data Formatting
- Glossary
- Index
- Test Symbols
- Back Cover
3–22 Configuring Your Scanner
Publication 2755-6.3
Configuration Sequence
To configure the scanner:
1. Connect the base/charger unit to the host device. Refer to
Chapter 2 for more information.
2. Make sure the scanner gun has a fully charged battery. Refer to
Chapter 2 for more information.
3. Pair the scanner to the base/charger unit. Refer to Chapter 2 for
more information.
4. Decide if the default values meet your requirements. Refer to
page 3–3 for a listing of the default parameters. If the default
values meet your requirements, scan the Set Defaults bar code
located in the Hand-Held Cordless Bar Code Scanners
Programming Guide (Publication No. 2755-6.6). If the default
parameters do not meet your requirements, scan the appropriate
bar codes for the options you need found in the Hand-Held
Cordless Bar Code Scanners Programming Guide (Publication
No. 2755-6.6). It is recommended that you scan the Set Defaults
bar code before entering any additional bar codes. The scanner
parameters may be configured in any sequence.