User guide
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Installing Your Hardware
- Important Notes on Scanner Systems
- 1. Unpacking the Equipment
- 2. Setting the Address of the Base/Charger Unit
- 3. Connecting the Host Cable to the Base/Charger Unit
- 4. Mounting the Base/Charger Unit
- 5. Mounting the Power Supply
- 6. Connecting the Power Supply to the Base/Charger Unit and Power Receptacle
- 7. Connecting the Host Cable to the Host Device
- 8. Charging the Battery
- 9. Pairing the Scanner to the Base/Charger Unit
- 3 - Configuring Your Scanner
- 4 - Scanner Operation
- 5 - Maintenance and Troubleshooting
- A - Specifications
- B - Cable Pinouts
- C - Advanced Data Formatting
- Glossary
- Index
- Test Symbols
- Back Cover
3–16 Configuring Your Scanner
Publication 2755-6.3
Data Transmission Formats
You can set whether or not prefix or suffix data is added to the
decoded symbol data. You have four options:
• <DATA AS IS> Only bar code data is sent. This is the default
setting.
• <DATA> <SUFFIX> Bar code data is sent, then the suffix data.
• <PREFIX><DATA><SUFFIX> Prefix data is sent, then bar
code data followed by the suffix data.
• <PREFIX> <DATA> Prefix data is sent then the bar code data.
Laser On Time-Out
This setting determines the maximum time the scanner remains on
while the trigger is pressed. The time-out is programmable in
0.5 second increments from 0.5 seconds to 3.0 seconds.
Baud Rate
Sets the rate (bits per second) at which the scanner transmits data.
The scanner baud rate setting must match the host setting. If the
settings do not match, data may not reach the host device or reach it
in distorted form. The selections are:
• 600
• 1200
• 2400
• 4800
• 9600 (default)
• 19200