User guide
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Installing Your Hardware
- Important Notes on Scanner Systems
- 1. Unpacking the Equipment
- 2. Setting the Address of the Base/Charger Unit
- 3. Connecting the Host Cable to the Base/Charger Unit
- 4. Mounting the Base/Charger Unit
- 5. Mounting the Power Supply
- 6. Connecting the Power Supply to the Base/Charger Unit and Power Receptacle
- 7. Connecting the Host Cable to the Host Device
- 8. Charging the Battery
- 9. Pairing the Scanner to the Base/Charger Unit
- 3 - Configuring Your Scanner
- 4 - Scanner Operation
- 5 - Maintenance and Troubleshooting
- A - Specifications
- B - Cable Pinouts
- C - Advanced Data Formatting
- Glossary
- Index
- Test Symbols
- Back Cover
3–12 Configuring Your Scanner
Publication 2755-6.3
Convert UPC-E to UPC-A
When enabled, this option converts UPC-E (zero suppressed)
decoded data to a UPC-A format before sending the data. After
conversion, output data will be affected by UPC-A programming
selections such as preamble and check digit settings.
EAN Zero Extend
When enabled, five leading zeros are added to decoded EAN 8
symbol data. The five zeros make the EAN 8 symbols compatible
with the EAN 13 format.
Transmit No Decode Message
When enabled, a NR is transmitted with each no-read. Prefixes and
suffixes appear with the output message.
UPC / EAN Supplemental
When enabled, supplemental digits are decoded. If the supplemental
digits are not enabled and a bar code having supplemental digits is
read, the supplemental digits are ignored. On the other hand, if
supplemental digits are enabled, only bar codes with supplemental
digits are decoded.
I 2 of 5 (14 digit) to EAN 13 Conversion
When enabled, 14 character Interleaved 2-of-5 data is converted and
transmitted to the host in an EAN 13 format. The I 2 of 5 code must
be enabled, have one length set to 14, have a leading zero, and have
a valid EAN-13 check digit.
Code 39 Check Digit
When enabled, the scanner verifies the Code 39 check digit
(modulo 43 check character).