User guide
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Installing Your Hardware
- Important Notes on Scanner Systems
- 1. Unpacking the Equipment
- 2. Setting the Address of the Base/Charger Unit
- 3. Connecting the Host Cable to the Base/Charger Unit
- 4. Mounting the Base/Charger Unit
- 5. Mounting the Power Supply
- 6. Connecting the Power Supply to the Base/Charger Unit and Power Receptacle
- 7. Connecting the Host Cable to the Host Device
- 8. Charging the Battery
- 9. Pairing the Scanner to the Base/Charger Unit
- 3 - Configuring Your Scanner
- 4 - Scanner Operation
- 5 - Maintenance and Troubleshooting
- A - Specifications
- B - Cable Pinouts
- C - Advanced Data Formatting
- Glossary
- Index
- Test Symbols
- Back Cover
Installing Your Hardware 2–11
Publication 2755-6.3
7. Connecting the Host Cable to the Host Device
The following sections describe how to connect the host cable to the
host device.
Connecting a RS-232C Cable to the Host Device
!
ATTENTION: Do not install the RS-232C cable
(Catalog Nos. 2755-HCC-BR1-06 or -BR2-06) or
disconnect/connect the host device with power applied
to the host device. Failure to follow this caution may
result in damage to the base/charger unit, RS-232C
cable, or host device.
To connect the RS-232C cable to the host device:
1. Disconnect power from your host device.
2. Plug the RS-232C cable into the host device.
To Host Device
RS-232C Cable
Base/Charger Unit
3. Reconnect power to your host device.