User guide
Table Of Contents
- Front Cover
- Important User Information
- Table of Contents
- Preface
- 1 - Scanner Features
- 2 - Installing Your Hardware
- Important Notes on Scanner Systems
- 1. Unpacking the Equipment
- 2. Setting the Address of the Base/Charger Unit
- 3. Connecting the Host Cable to the Base/Charger Unit
- 4. Mounting the Base/Charger Unit
- 5. Mounting the Power Supply
- 6. Connecting the Power Supply to the Base/Charger Unit and Power Receptacle
- 7. Connecting the Host Cable to the Host Device
- 8. Charging the Battery
- 9. Pairing the Scanner to the Base/Charger Unit
- 3 - Configuring Your Scanner
- 4 - Scanner Operation
- 5 - Maintenance and Troubleshooting
- A - Specifications
- B - Cable Pinouts
- C - Advanced Data Formatting
- Glossary
- Index
- Test Symbols
- Back Cover
Chapter 2
Publication 2755-6.3
Installing Your Hardware
This chapter describes how to install your hardware. Included is the
following sequence on installing your scanner system hardware.
1. unpacking the equipment
2. setting the address of the base/charger unit
3. connecting the host cable to the base/charger unit
4. mounting the base/charger unit
5. mounting the power supply
6. connecting the power supply to the base/charger unit and power
receptacle
7. connecting the host cable to the host device
8. charging the battery
9. pairing the scanner to the base/charger unit