User guide

Chapter 6
Publication 2755-6.7
Scanner Emulation Cable
(Communication Setup)
This chapter provides the configuration bar codes for the scanner
emulation Synapse cable:
• (Catalog No. 2755-HFC-SA1-01)
Scanner Emulation Synapse Cable Defaults
Scan the following bar code to set the scanner emulation cable to its
default values. Defaults are indicated with an asterisk *.
Set Scanner Emulation Cable Defaults
Scan this label to set the Scanner Emulation Synapse cable to the
default settings shown below.
Scanner Emulation
Synapse Cable
Default Setting
Code on
Page:
Emulation Standard 6–2
Leading Margin 80 Millisecond 6–3
Decode LED Enabled 6–3
Emulation Timeout 3 Seconds 6–4
Polarity Margin Low / Bar High 6–5
Unknown Characters
Send Bar Codes with Unknown
Characters
6–5
Convert All to Code 39 Disabled 6–6
Code 39 to Code 39 Full ASCII Disabled 6–6
Parameter Set Parameter Set 1 6–7