User guide

1–2 Scanner Configuration
Publication 2755-6.7
The scanner is now set to these defaults:
Scanner Configuration Parameters Default Setting
Code on
Page:
Set Default Parameters 1–1
Symbologies All Enabled 1–3
Code 39 Full ASCII Enabled 1–6
Transmit Code 39 Check Digit Enabled 1–6
Transmit UPC-A Check Digit Enabled 1–7
Transmit UPC-E Check Digit Enabled 1–7
Convert UPC-E to UPC-A Disabled 1–7
Decode UPC / EAN Supplements Disabled 1–8
Convert EAN-8 to EAN-13 Disabled 1–9
UPC-A Preamble System Character 1–9
UPC-E Preamble System Character 1–9
Code 39 Code Lengths 1-55 1–10
Codabar Code Length 2-55 1–11
Interleaved 2 of 5 Code Length 14 1–12
Prefix/Suffix Enter 1-17
Data Transmission Format Data As Is 1–16
Transmit No-Read Message Disabled 1–17
Transmit LRC Checksum Disabled 1–17
Transmit Code ID Character Disabled 1–18
Beep After Good Decode Enabled 1–19
Beeper Tone High 1–19
Decode Buffering Disabled 1–19
Pause Duration 0.0 seconds 1–20
Decode Attempt Duration 0.5 seconds 1–20
Time Delay to Power Mode 30 seconds NO TAG
Timeout Between Decodes - Same Symbol 0.6 seconds NO TAG
Timeout Between Decodes - Different Symbols 0.0 seconds NO TAG
Smart Raster Enabled 1–22
Hand-Held Options Slab Raster 1–22