Installation Instructions Instruction Manual

ManualsBrandsRockwell Automation ManualsEquipment2711P-RNxxx Communication Modules

Installation Instructions

Communication Modules

Catalog Numbers 2711P-RN6, 2711P-RN6K, 2711P-RN15S, 2711P-RN15SK, 2711P-RN20

About This Publication

This document provides instructions on how to install or replace a communication module on a

PanelView Plus™ 6 or PanelView Plus 700, 1000, 1250, or 1500 terminal.

The communication module installs over the logic module. The installation is the same for all

communication modules regardless of communication type.

Additional Resources

You can view or download publications at http://www.rockwellautomation.com/literature/. To

order paper copies of technical documentation, contact your local Allen-Bradley distributor or

Rockwell Automation sales representative.

Topic Page

Important User Information 2

Install a Communication Module 3

Replace a Communication Module 4

Cat. No.

(1)

(1) These installation instructions also apply to other cat. no. 2711P-RNxx communication modules.

Communication

Conformal

Coated

Marine

Certified

Ethernet DH+™ DH-485 Remote I/O

(3)

(3) Only supported on PanelView Plus 700 to 1500 terminals running FactoryTalk® View Machine Edition software, version 5.1 or earlier.

ControlNet

2711P-RN6 • • •

2711P-RN6K • • • •

2711P-RN15S • •

2711P-RN15SK • •

2711P-RN20

(2)

(2) Only supported on PanelView Plus 6 - 700 to 1500 terminals running firmware revision 6.10.17 or later.

•

IMPORTANT

The logic module must be attached to a PanelView Plus display module before you attach the

communication module.

Summary of content (4 pages)

PAGE 1
Installation Instructions Communication Modules Catalog Numbers 2711P-RN6, 2711P-RN6K, 2711P-RN15S, 2711P-RN15SK, 2711P-RN20 Topic Page Important User Information 2 Install a Communication Module 3 Replace a Communication Module 4 About This Publication This document provides instructions on how to install or replace a communication module on a PanelView Plus™ 6 or PanelView Plus 700, 1000, 1250, or 1500 terminal. Cat. No.
PAGE 2
Communication Modules Important User Information Solid-state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines for the Application, Installation and Maintenance of Solid State Controls (Publication SGI-1.1 available from your local Rockwell Automation sales office or online at http://www.rockwellautomation.com/literature/) describes some important differences between solid-state equipment and hard-wired electromechanical devices.
PAGE 3
Communication Modules 3 Install a Communication Module WARNING: Explosion Hazard Do not connect or disconnect any communication cable with power applied to this device or any device on a network. An electrical arc could cause an explosion in hazardous location installations. Be sure power is removed or the area is known to be nonhazardous before proceeding. ATTENTION: Work in a static-free environment and wear a properly grounded electrostatic discharge (ESD) wristband.
PAGE 4
5. Push down on the communication module until the connectors are seated. 6. Tighten the four screws that secure the communication module to the logic module to a torque of 0.58 N•m (5…7 lb•in). Replace a Communication Module Follow these steps to replace a communication module. 1. Disconnect power from the terminal. 2. Disconnect communication cables from the module. WARNING: Explosion Hazard Do not connect or disconnect any communication cable with power applied to this device or any device on a network.