Quick Start User Manual
Table Of Contents
- 2711C-QS001F-EN-P PanelView Component HMI Quick Start
- Where to Start
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Chapter 4
- Chapter 5
- Chapter 6
- Create the Motor Status Screen
- Introduction
- Before You Begin
- What You Need
- Follow These Steps
- Change the Screen Name
- Change the Grid Attributes
- Create the Start Motor Push Button
- Create the Stop Motor Push Button
- Create the Motor Speed Screen Button
- Create a Goto Config Button
- Create the Motor Control List Selector
- Create the Motor Status Indicators
- Save the Motor Status Screen
- Create the Motor Status Screen
- Chapter 7
- Create the Motor Speed Screen
- Introduction
- Before You Begin
- What You Need
- Follow These Steps
- Create a New Screen
- Create the Motor Status Screen Button
- Create a Numeric Entry Object
- Create a Heading for the Numeric Entry Object
- Create a Increment Decrement Object
- Create Increment Decrement Keys
- Create a Bar Graph
- Create a Bar Graph Scale
- Create Text Labels for the Scale
- Create a Bar Graph Heading
- Create a Numeric Display
- Create a Heading for the Numeric Display
- Update the Motor Speed Screen Button
- Create the Motor Speed Screen
- Chapter 8
- Chapter 9
- Appendix A
- Back Cover
94 Publication 2711C-QS001F-EN-P - November 2010
Chapter 9 Validate and Run Application
Follow These Steps
Complete these steps to run the sample application on the terminal while connected to the MicroLogix
controller.
About the MicroLogix Controller
For the purpose of this quick start, the MicroLogix 1100 and PanelView components are not mounted in a
panel but are in a desktop configuration. This quick start does not provide MicroLogix specific information,
such as wiring, mounting, configuring, or loading the ladder logic file, QuickStart.rss.
For more information on the MicroLogix 1100 controller, refer to the Additional Resources in the preface of
this quick start.
page 97
Validate the
Application
Connect Terminal
to Controller
Download Ladder
Logic to
Controller
page 96
page 96
page 97
Run the
Application
Run the Motor in
Manual Mode
Run the Motor in
Automatic Mode
page 98
page 101
Go to
Configuration
Mode
page 102