Owner manual

Variable Content TTL:Chap Is Linked To HD:Running 3
2. Alternately tighten the mounting clips screws to a torque of 10 inch-pounds.
Do not over-tighten the clips.
!
ATTENTION: Tighten mounting clips to a torque of 10 inch-pounds
to provide a proper seal and to prevent damage to the terminal.
Allen-Bradley assumes not responsibility for water or chemical damage
to the terminal or other equipment within the enclosure because of
improper installation.
!
ATTENTION: Remove the protective installation label covering the
top vents to prevent overheating and damage to the terminal.
3. Remove the protective label covering the top vents of the terminal.