Manual

ManualsBrandsRockwell Automation ManualsEquipment2711-NL2_NL3_NL4 Display Backlight

Publication 2711-IN042C-EN-P - July 2007

Installation Instructions

PanelView Display Backlight

Catalog Numbers

About This Publication

This publication describes how to replace the backlight in the PanelView 1000

Color, PanelView 900 Color, and PanelView 600 terminals.

Terminal Backlight Cat. No.

PanelView 1000 Color 2711-NL4

PanelView 900 Color 2711-NL2

PanelView 600 2711-NL3

Topic Page

About This Publication 1

Important User Information 2

Safety Precautions 3

About the Backlight 3

Remove the Backlight 3

Install the Backlight 5

Backlight Disposal 6

Summary of content (8 pages)

PAGE 1
Installation Instructions PanelView Display Backlight Catalog Numbers Terminal Backlight Cat. No.
PAGE 2
PanelView Display Backlight Important User Information Solid state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines for the Application, Installation and Maintenance of Solid State Controls (publication SGI-1.1 available from your local Rockwell Automation sales office or online at http://literature.rockwellautomation.com) describes some important differences between solid state equipment and hard-wired electromechanical devices.
PAGE 3
PanelView Display Backlight 3 Safety Precautions ATTENTION Disconnect all power from the PanelView terminal before replacing the backlight. Failure to disconnect power may result in electrical shock and/or damage to the terminal. ATTENTION Do not touch any of the exposed electronic components to prevent damage from electrostatic discharge (ESD). About the Backlight The backlight uses cold cathode fluorescent (CCF) tubes to illuminate the display.
PAGE 4
PanelView Display Backlight 3. Open the back of the PanelView terminal by swinging the unit open about 90°. Avoid touching exposed electronic components. 4. Unplug the backlight power supply cable and remove it from the molded cable retainers (not present on PV600 terminal) on the backlight reflector and set aside.
PAGE 5
PanelView Display Backlight 5 Install the Backlight Follow these steps to install the backlight in the terminal. 1. Place the new backlight on the four backlight standoffs. 2. Replace the four backlight mounting screws and tighten to a torque of 0.7…0.9 Nm (6…8 lb-in). 3. Place the backlight power supply cable under the cable retainers on the backlight reflector (PV900C/PV1000C terminals only) and plug into the new backlight. 4.
PAGE 6
PanelView Display Backlight Backlight Disposal IMPORTANT The backlight in this product contains mercury. At the end of its life, this equipment should be collected separately from any unsorted municiple waste.
PAGE 7
PanelView Display Backlight 7 Notes: Publication 2711-IN042C-EN-P - July 2007
PAGE 8
Rockwell Automation Support Rockwell Automation provides technical information on the Web to assist you in using its products. At http://support.rockwellautomation.com, you can find technical manuals, a knowledge base of FAQs, technical and application notes, sample code and links to software service packs, and a MySupport feature that you can customize to make the best use of these tools.