Quick Start Manual User Manual

82 Publication 2711-QS003D-EN-P - June 2009
Appendix A Application Programs
SLC Controller Programs (\QuickStart\SLC directory)
File Name For Use with this Application Page
dh485.rss • Channel 0 must be used on an SLC-5/04 or 5/05
controller with a 1761-NET-AIC Link Coupler
94
df1.rss • SLC 5/03, 5/04, 5/05 controller
• Channel 0 configured for DF1, no-parity, CRC, and no
handshaking.
• Baud rate set at 9600
Important: You may need to convert the ladder logic for
the appropriate controller.
90
dhp.rss • SLC 5/04 controller
• Channel 1 configured for DH+ at 57.6K baud.
98
dnet.rss • SLC 5/02, 5/03, 5/04, 5/05 controller
• 1747-SDN DeviceNet scanner in slot 1
• Baud rate set at 125K
Important: You may need to convert the ladder logic for
the appropriate controller.
100
rio.rss • SLC 5/02, 5/03, 5/04, 5/05 controller
• 1747-SN scanner in slot 1
• Baud rate set at 57.6K
Important: You may need to convert the ladder logic for
the appropriate controller.
102
enet.rss • SLC 5/05E (Ethernet) controller
• IP Address is 10.0.0.1
104
MicroLogix Controller Programs (\QuickStart\ML directory)
File Name For Use with this Application Page
df1.rss • MicroLogix 1000 Series C or later controller
Important: You may need to convert the ladder logic for
the appropriate controller.
92
dh485.rss • MicroLogix 1000 Series C or later controller
• 1761-NET-AIC Link Coupler may be needed
• Channel 0 must be used on an SLC-5/04 or 5/05 with a
1761-NET-AIC Link Coupler
Important: You may need to convert the ladder logic for
the appropriate controller.
96