Software Instruction Manual

Chapter 2
Installing / Running
DTAM Programming Software
2–6
To run the DTAM Programming Software:
1. Verify that you are at the \DPS subdirectory where the software resides.
If you are not, enter cd \DPS and press [Return].
C:\DPS>
2. Type DPS and press [Return] to start the program.
C:\DPS> DPS [Return]
3. Specify whether you are using a color monitor. Enter [Y] or [N].
The startup screen displays. It identifies the DPS version and licensed
owner. A phone support number is provided for your assistance.
Voice: 440–646–6800
FAX: [phone] or 6890
E–mail: [e-mail]
Technical Support
Followed by this screen.
Running DPS
☞ If you installed the software in
another subdirectory, move to
that directory.