Operator Interface Module Instruction Manual

Chapter 8
Troubleshooting and Maintenance
8–8
Use the keyboard test to verify that the keyboard is functioning properly.
To perform the keyboard test:
1. Use the [NEXT] and [PREV] keys to display Keyboard on the
test selection screen.
DTAM Micro Diag Test
Keyboard
2. Press [ ] to initiate the test.
The DTAM Micro prompts you to press each key in a sequential order.
Press “F1”
3. Press the keys as prompted form left to right beginning at the top.
Begin
End
You must press all of the keys in the order prompted. If you press the
wrong key, you must start over with the first key.
4. Pressing the last key in the sequence terminates the keyboard test.
The next test selection screen is displayed.
DTAM Micro Diag Test
Comm Port
5. To terminate the test function , press the [NEXT] and [PREV] keys to
display Reset DUT in the test selection area. Press [
] to reset the
terminal.
Keyboard Test