Operator Interface Module Instruction Manual

Chapter 3
Initial Setup and Mode Menu
3–5
Use the reset function to reset the DTAM Micro after DIP switch changes or
a configuration change using the Mode Menu.
To reset the DTAM Micro:
1. From the Mode Menu select 1 Reset.
1 Reset 3 Special
2 Com-Port 4 Other
You are prompted:
1 = Reset DTAM Micro
0 = Abort
2. Press [1] on the keypad to initiate the reset.
The DTAM Micro resets. This has the same effect as turning the power
off and on. The DTAM Micro performs the self diagnostic tests and
powerup displays as described in the previous section.
Resetting the DTAM Micro