Operator Interface Module Instruction Manual

A–B
3
Chapter
3–1
Initial Setup and Mode Menu
This chapter describes how to apply power to and then configure the DTAM
Micro using the menu keys. Instructions on how to use the Simulate mode to
run an application are provided. This chapter contains the following
sections:
Section Page
Apply Power 3–2
Powerup Sequence 3–3
Mode Menu 3–4
Resetting the DTAM Micro 3–5
Setting Communication Parameters Manually 3–6
Special Functions for Controller Operations 3–7
Entering a New Master Security Code 3–8
Enabling / Disabling Scaling 3–9
Using the Simulate Mode 3–10
Test Functions 3–11
Objectives