Installation Instructions Owner's manual

Special Controller Functions
Appendix C
C–21
Use the Clear Fault function to clear all major and minor faults in the logic
controller.
To clear controller faults:
1. If you are clearing a PLC, the controller must be in Program or Remote
Program mode.
2. Select item 4 from the Special Menu to access the Clear Fault function.
You are prompted to clear faults:
Clear SLC Fault
Press ”Y”To Clear
All SLC 50X Faults
Press ”N” To Exit
Press ”Y”To Clear
All PLC 5 Faults
Press ”N” To Exit
SLC Controllers PLC Controllers
3. Press [Y] to clear the faults or [N] to abort the function.
The faults are cleared and you are returned to the special functions menu:
Using the Clear Fault
Function