USER MANUAL User guide

Publication 2706-6.3
Startup Sequence
When power is applied to the DL40 Plus Slave a powerup sequence
of displays are shown. The first display on powerup is the sign-on
banner identifying the hardware and firmware:
Following the sign-on banner, all of the display pixels are turned on
for 2 seconds followed by a series of informational messages
indicating the current DIP switch settings. Each display lasts for
about four seconds.
After the status messages are displayed, the DL40 Plus Slave clears
the display and enters the selected run mode.
DL40 PLUS SLAVE 2L
VER 1.00 (10/16/98)
DL SLAVE MODE
ENGLISH TEXT
SERIAL ADDRESS: XXX
19200 BAUD (N-8-1)
300
CURSOR ENABLED
AUTO LINE ENABLED