USER MANUAL User guide

Publication 2706-6.3
RS-232 Connections
Use the RS-232 port to connect the DL40 Plus Slave to:
• DL40 Plus Master
• PanelView Printer Port
• 1771 or 1746-DB BASIC Module
• PLC-5 Channel 0
• SLC Channel 0
The following figure shows the location and terminal definitions for
the RS-232 port.
DL40 Plus Slave to DL40 Plus Master RS-232 Port
Connect a single DL40 Plus slave to a DL40 Plus master as shown
below. You can also use the DTAM Plus programming cable
(Catalog No. 2707-NC2) with a male-female pin adapter.