USER MANUAL User guide

Publication 2706-6.3
Chapter
2
Setting the DIP Switches
Chapter Objectives
This chapter describes how to configure the DL40 Plus Slave display
using the configuration DIP switches. The following topics are
provided:
• DIP switch location
• Selecting the operating mode
• Selecting display language
• Setting the baud rate
• Selecting display/communication options
• Setting display address
DIP Switch Location
Access the 10-position DIP switches from the back of the display. Set
DIP switches using a thin nonconductive object. Do not use a pencil
(broken graphite pieces may short out the internal circuitry).
Changes to DIP switches take affect on powerup. If you make
changes with the power applied, you will have to cycle power before
the changes take effect.
10-Position DIP Switch
↑
Up = ON
↓
Down = OFF
N
O
12 34 56 78 910
N
O
1234 5678910