INSTALLATION MANUAL User Manual

A–B
3
Chapter
3–1
Configuring the DL50
This chapter describes how to configure the DL50 using DIP switches.
Figure 3.1 shows the location of the DIP switches used for configuration.
Figure 3.1
DIP Switch Locations
DL50
Pr
ocesso
r
Boa
r
d
(Refer to Figure 2.2 for Location)
DIP Switch S1 DIP Switch S2 DIP Switch S3
RESET
RESET
1 2345678
O
F
F
1 2345678
O
F
F
1 2345678
O
F
F
The three 8 position DIP switches select the following functions:
• Slave Address
• Duplex or Simplex Protocol
• Character Height
• Baud Rate
• Mode Selection
• Checksum Enable/Disable (Duplex protocol only)
• Default Color (Tri-color displays only)
Chapter Objectives
DIP Switch Locations
DIP Switch Functions