Repair Kit Instruction Manual

41061-095-01(A)

Instructions

DL40 Plus Faceplate Repair Kit

Part No. W77156-800-01 (2-Line DL40 Plus)

W77156-800-02 (4-Line DL40 Plus)

W77156-800-03 (2-Line DL40 Plus Slave)

W77156-800-04 (4-Line DL40 Plus Slave)

DL40 Plus Message Display

(2706-LV2x, -LV4x)

1 2

Remove four screws securing top circuit board. Disconnect ribbon cable from circuit

board below. Place board in a safe anti-static area.

Important: Note location of ribbon cable. Remove ribbon cable by the connector, do not

pull on the cable. The ribbon cable has a small latch in the middle that must be pressed in

to release the cable connector from the circuit board connector.

Remove four screws and back cover.

PAGE 1
Instructions DL40 Plus Faceplate Repair Kit Part No. W77156-800-01 (2-Line DL40 Plus) W77156-800-02 (4-Line DL40 Plus) W77156-800-03 (2-Line DL40 Plus Slave) W77156-800-04 (4-Line DL40 Plus Slave) DL40 Plus Message Display (2706-LV2x, -LV4x) 1 3 2 Remove four screws and back cover. Remove four screws securing top circuit board. Disconnect ribbon cable from circuit board below. Place board in a safe anti-static area. Important: Note location of ribbon cable.
PAGE 2
4 ! ATTENTION: Be careful not to nick or damage circuit board components when removing spacers. Some spacers are very close to board components. Medium Length Spacers Long Spacers Remove two screws and two spacers securing the second board. Note the location of the spacers and screws as they are removed. Place board in a safe anti-static area. 4-Line displays, remove three screws and 5 On five spacers securing the last board to the faceplate. On 2-Line displays, remove six spacers securing the board.