USER MANUAL

A–B
E
Appendix
E–1
Setting Keyboard Baud Rate
This appendix provides instructions for setting the baud rate on keyboards
(Catalog No. 2706-NK1 or -NK2).
Before the 2706-NK1 or 2706-NK2 keyboards can be connected to the
DL20, the baud rate of the keyboard must match the display baud rate.
Displays are shipped from the factory with a baud rate of 9600. The
keyboard baud rate must be set to 9600 to work with a DL20.
Use the following procedures to change or verify the keyboard baud rate
1. Turn the keyboard over and slide the DIP switch access door open.
Access door
CableCable
Bottom view
Bottom view
Cat. No. 2706-NK1
Full Travel Keyboard.
Cat. No. 2706-NK2
Membrane Keyboard.
2. Set DIP switch to appropriate baud rate.
ON
2341
ON=UP=CLOSED
OFF=DOWN=OPEN
BAUD RATE SWITCH SETTINGS
Baud Rate
SW1 SW2 SW3 SW4
300 OFF OFF ON ON
1200 OFF OFF OFF ON
9600 OFF OFF OFF OFF
BAUD RATE SWITCH SETTINGS
Baud Rate
SW1 SW2
300 ON ON
1200 ON OFF
9600 OFF OFF
ON
21
2706-NK1 DIP Switch 2706-NK2 DIP Switch
Note: When programming the DL20, it is possible to change the baud rate
of the serial port. Once this baud rate is changed, the keyboard baud rate
must be changed to match.
Overview
Setting Baud Rate