User Manual

4
Installation and Mounting
The setting of the DIP switch on the circuit board determines:
• DeviceNet node address
• DeviceNet data rate
• Output flash rate
• Output fault state
The location of the DIP switch and the factory defaults are shown
below.
DIP Switches
OFF = 0
ON = 1
10 123456789
Setting the DeviceNet Node Address
DIP switches 1 to 6 set the node address (0 to 63) of the
RediSTATION on the DeviceNet network. The address is set using
binary addressing.
DeviceNet Address 000000 – 111111 (0 to 63)
OFF = 0
ON = 1
10 123456789
The table below shows the switch settings for each address (0 to 63).
To set the DeviceNet node address:
1. Refer to the table below for switch settings of a specific address.
2. Using your finger or a pointed object, slide switches 1 through 6
to the appropriate ON/OFF positions.
!
ATTENTION: Do not use a pencil. Graphite from the pencil
is conductive and may damage the DIP switch.
Setting the DIP Switches