User Manual

68 Rockwell Automation Publication 20P-UM001K-EN-P - July 2014
Chapter 1 Installation and Wiring
Figure 47 - SA-SB Terminal Block Location on Frame B Drives
Figure 48 - SA-SB Terminal Block Location on Frame C Drives
Front of Drive
Top, right side of drive.
Switching power supply board SA-SB terminals Back of control board EMI shield
The SA-SB terminal block is on the switching power supply
circuit board on the back of the control board EMI shield.
1. Remove the top protective cover from the drive.
3. Loosen
captive
screws.
2. Disconnect cables XFCD and XR.
4. Lower control
board EMI shield
and disconnect
cable XSW from
switching power
supply board (see
above).
XSW connector
To access the SA-SB terminal block:
3. Loosen captive
screws.