User Manual

Rockwell Automation Publication 20P-UM001K-EN-P - July 2014 395
Index
Max Fld Curr Pct (Par. No. 467) 130
Max Ref Speed (Par. No. 45)
128
Max Speed Fwd (Par. No. 3)
145
Max Speed Rev (Par. No. 4)
145
Maximum Speed (Par. No. 2)
145
menu
HIM
268, 269
MicroPsnScalePct (Par. No. 1112)
170
Min Fld Curr Pct (Par. No. 468)
131
Min Speed Fwd (Par. No. 5)
145
Min Speed Rev (Par. No. 6)
145
Minimum Diameter (Par. No. 799)
162
Minimum Speed (Par. No. 1)
145
MOD LED
216
Monitor file
123-127
MOP Accel Time (Par. No. 22)
152
MOP Dec Active (Par. No. 397)
177
MOP Decel Time (Par. No. 30)
152
MOP Inc Active (Par. No. 396)
176
MOP Mask (Par. No. 598)
188
MOP Owner (Par. No. 607)
188
MOP Ref Config (Par. No. 249)
173
MOP Select (Par. No. 1375)
173
Motor Control file
128-144
Motor Data group
128-129
motor not reaching commanded speed
228
motor not turning
228
Motor Over Temperature alarm
225
Motor Over Temperature fault
219
Motor Overload alarm
225
Motor Overload fault
219
motor reaches maximum speed immediately
229
Motor Trq Ref (Par. No. 17)
125
motor turning wrong direction
228
mount
drive
18
lift
25
mounting
dimensions
19
weights
19
MtrOvrld Factor (Par. No. 333)
129
MtrOvrld Flt Cfg (Par. No. 479)
182
MtrOvrld Speed (Par. No. 334)
129
MtrOvrld Status (Par. No. 1290)
177
MtrOvrld Type (Par. No. 376)
129
N
NET A LED 216
NET B LED
216
Nom Mtr Arm Amps (Par. No. 179)
128
Nom Mtr Fld Amps (Par. No. 280)
128
numbered parameter list
269
O
Offs Accel Time (Par. No. 1198) 166
Open SCR fault
219
Opening Delay (Par. No. 1263)
154
OpenSCR Flt Cfg (Par. No. 216)
144
OpenSCR Threshld (Par. No. 217)
144
OpenSCR Trip Lvl (Par. No. 218)
144
OpenSCR WarnLvl (Par. No. 215)
144
Out Volt Level (Par. No. 921)
133
Output Power (Par. No. 1052)
127
Output Voltage (Par. No. 233)
126
Overcurrent fault
219
OverCurrent Thr (Par. No. 584)
182
Overspeed fault
220
Overspeed Val (Par. No. 585)
183
OverTemp Flt Cfg (Par. No. 365)
181
OverVolt Flt Cfg (Par. No. 203)
181
overvoltage clipping circuit board, frame D
fuses
253
P
Param Access Lvl (Par. No. 211) 173
parameter access level
change
269
parameter files
Applications
157-172
Communications
187-190
Dynamic Control
151-156
Input/Output 191-202
Monitor
123-127
Motor Control
128-144
Speed Command 145-150
Utility
173-187