User Manual

Rockwell Automation Publication 20P-UM001K-EN-P - July 2014 31
Installation and Wiring Chapter 1
When operating a drive with firmware version 1.006 in field weakening mode
with a DC contactor or inverting fault device that is installed in the armature
circuit, see Field Weakening Mode Configuration (v1.006) on page 285
.
AC Input Contactors
See AC Input Line Reactors and AC Input Contactors on page 254 for a list of
recommended AC input contactors.
DC Output Contactors
A DC output contactor can be used to connect the output of the armature circuit
to the DC motor. If a DC output contactor is used, an AC input contactor is not
needed.
See Dynamic Brake Resistor Kits and DC Output Contactors on page 258
for a
list of recommended DC output contactors.
Dynamic Brake Resistors
See Dynamic Brake Resistor Kits and DC Output Contactors on page 258 for a
list of recommended dynamic brake resistor kits.