User Manual

Rockwell Automation Publication 20P-UM001K-EN-P - July 2014 253
Supplemental Drive Information Appendix A
Frame D Overvoltage Clipping Circuit Board Fuses
The following fuses are used to protect the resistors and capacitors on the
overvoltage clipping circuit board for frame D drives only.
The overvoltage
clipping circuit board is on the left side wall inside the drive enclosure,
behind the control panel.
Figure 83 - Frame D Overvoltage Clipping Circuit Board Fuse Locations
Circuit Board ID / Revision Designation Fuse (14 x 51 mm)
CFSFxxx / All F11/F21/F31 10 A, 690V fast
Overvoltage clipping board fuse locations (shown with control panel open).