Owner manual

2
2. Disconnect all options connected to DSI
ports on the drive.
Important: Connected communication
options can interfere with the
flash process.
3. Connect the DSI cable and the
Serial cable to the Flash
Module.
4. Connect the 9-pin sub-miniature
D-shell female connector of the
Serial cable to a serial
communications port on a PC
computer.
5. Verify that the drive is Enabled.
The drive is Enabled if:
• ENBL Enable Jumper is installed
OR
• A valid input is supplied to
I/O Terminal 01
Important: The drive must be enabled
during the flash process.
RS485 (DSI) Ports
DSI Port
Enable Jumper Installed
on Control Board
Input at I/O Terminal 01
(2 Wire Control Example Shown)
11
01
02
Stop-Run
RS485
(DSI)
01 02 03 04 05
11 12 13 14 15
06 07 08 09
16 17 18 19
ENBL