User manual

AC Adjustable Frequency Drives
Important Safety and Product Information
163
Australian C-Tick Compliance
Allen-Bradley branded products covered by Australian acts are
intended for sale and use within the Australian market and
conform with the essential requirements of these acts. Declarations
of Conformity for Allen-Bradley branded products are available as
required.
Actual C-Tick conformity is indicated by the label on the product,
and not by statements in this catalog or any product literature.
ISO 9001 Registration
Rockwell Automation has registered facilities encompassing more
than 45 separate sites around the world to the ISO 9001 standard.
This registration means that its quality system governing the
design, development, manufacture, and delivery of its products has
been verified by third-party audits.
ControlNet Conformance
Products which have been determined by ControlNet International
to have passed conformance testing receive a Declaration of
Conformity from ControlNet International for the product.
Vendors who have received a Declaration of Conformity for a
product have the right to be use the ControlNet CONFORMANCE
TESTED certification logo mark and certification word mark on
the product and in materials about the product.
DeviceNet Conformance
The Conformance Tested Service Mark is an ODVA-controlled
logo protected by law, the authorized use of which indicates that a
product has passed conformance testing at an official ODVA Test
Service Provider (TSP). The DeviceNet conformance-tested
service mark may be placed on a product, its literature, and/or
advertising, only after it has successfully passed conformance
testing at an official independent test lab of the Open DeviceNet
Vendor Association.
EtherNet/IP Conformance
The Conformance Tested Service Mark is an ODVA-controlled
logo protected by law, the authorized use of which indicates that a
product has passed conformance testing at an official ODVA Test
Service Provider (TSP). The EtherNet/IP conformance-tested
service mark may be placed on a product, its literature, and/or
advertising, only after it has successfully passed conformance
testing at an official independent test lab of the Open DeviceNet
Vendor Association.
Contacting Standards Organizations
For contact information of organizations regarding standards that
may impact the installation, application and/or interoperability of
Allen-Bradley branded products, refer to the following on-line
address:
http://www.ab.com/en/epub/catalogs/12768/229240/229242/284
1186/tab12.html.
Specifying Enclosures
Specify the Correct Enclosure for your Motor Controls
Enclosure Selection Criteria
Enclosures for Non-Hazardous Locations
For a Degree of Protection Against:
Designed to
Meet Tests No. ✶
Type
For Indoor Use Outdoor Use Indoor or Outdoor
112133R3 44X6P
Incidental contact with enclosed equipment 6.2
99999999
Falling dirt 6.2
99999999
Rust 6.8
99999999
Circulating dust, lint, fibers and flyings 7
6.5.1.2 (2)
99 9999
Windblown dust 6.5.1.1 (2)
9999
Falling liquids and light splashing 6.3.2.2
99 9999
Rain (Test evaluated per 6.4.2.1) 6.4.2.1
99999
Rain (Test evaluated per 6.4.2.2) 6.4.2.2
9999
Snow and sleet 6.6.2.2
99999
Hosedown and splashing water 6.7
999
Occasional prolonged submersion 6.11 (2)
9
Oil and coolant seepage 6.3.2.2
99
Oil or coolant spraying and splashing 6.12
9
Corrosive agents 6.9
99999
✶ See below for abridged description of NEMA enclosure test requirements. Refer to NEMA Standards Publication No. 250 for complete test specifications.
7 Non-hazardous materials, not Class III ignitable or combustible.