User manual

AC Adjustable Frequency Drives
PowerFlex 700S
145
Internal Dynamic Brake Resistors
These resistors have a limited duty cycle. Refer to the PowerFlex
Dynamic Braking Selection Guide to determine if an internal
resistor will be sufficient for your application. An external resistor
may be required.
Internal Communication Adapters
Description
Cat. Code
(Position j)
None
N
ControlNet (Coax) Communication Adapter - DPI
C
DeviceNet Communication Adapter - DPI
D
EtherNet/IP Communication Adapter - DPI
E
ControlNet (Fiber) Communication Adapter - DPI
Q
Remote I/O Communication Adapter - DPI
R
RS-485 DF1 Communication Adapter - DPI
S
DriveLogix Comm Option, ControlNet (Coax) ‡§
1
DriveLogix Comm Option, ControlNet Redundant (Coax) ‡§
2
DriveLogix Comm Option, ControlNet (Fiber) ‡§
3
DriveLogix Comm Option, ControlNet Redundant (Fiber) ‡§
4
DriveLogix Comm Option, DeviceNet (Open Conn.) ‡§
5
DriveLogix Comm Option, EtherNet/IP (Twisted Pair) ‡§
6
‡ Must have the DriveLogix option.
§ Requires Expanded Cassette when used with Phase II Control.
Control Options - Phase II Control
Control Option Cassette
Logix
Expansion
Board SynchLink
Catalog
Code
(Position k)
Phase I
Control
N/A N/A Standard
N
Phase II
Control
Expanded No No
A
Expanded No Yes
B
Expanded Yes No
C
Expanded Yes Yes
D
Slim N/A No
G
Slim N/A Yes
H
Feedback Options
Description
Cat. Code
(Position l)
None
N
Resolver, 10…26V, 10 kHz, 10…16 bit §
A
Stegman - High Resolution Encoder Hyperface, 8.5V DC, 20
bit, 100k/r §
B
Multi-Device Interface - for Stegmann or Linear Temposonics §
C
2nd Encoder, 5V or 12V Configurable by the Drive §♣
E
Drive Guard Safe-Off (w/2nd Encoder)
S
§ Requires Expanded Cassette when used with Phase II Control.
♣ For use with Phase II Control Only.
Additional Configurations
Description
Embedded
Communication
Cat. Code
(Position m)
Phase I Control N/A
N
Phase I Control, with DriveLogix5720
Controller, 256k bytes of User Memory
N/A
A
Phase I Control, with DriveLogix5720
Controller, 768k bytes of User Memory
N/A
B
Phase II Control No
E
Phase II Control, with DriveLogix5730
Controller
No
K
Phase II Control, with DriveLogix5730
Controller
EtherNet/IP
L
Drive Input Voltage Frame
Brake Resistance
Cat. Code
Ω
(Position h)
208…240V ac
1 (0.5-5.0 Hp) 62
Y
1 (7.5 Hp) 22
Y
222 Y
380…480V ac
1 115
Y
262 Y
All –
N
Internal EMC Filter
Drive Input Voltage CE Filter Frame
Cat. Code
(Position i)
208/240V ac Standard 1…6 A
380…480V ac Standard 1…6 A
380…500V ac
✶
No
9 7
N
380…500V ac Standard
9 & Up 7
B
600…690V ac Standard 1…6
A
✶ For use on ungrounded distribution systems.
7 For use with Phase I Control ONLY.