User manual

Installing the WIM 2-3
4. The status LED on the WIM momentarily flashes red on powerup
and then flashes green to indicate it is ready to establish wireless
communication with the Pocket PC or computer.
5. Establish wireless communication between the WIM and the Pocket
PC or computer. For this procedure, refer to the respective section in
Chapter 3 that corresponds to the drive software tool you are using:
• Using Pocket DriveExplorer for Pocket PC
on page 3-2
• Using DriveExplorer/DriveExplorer Lite on page 3-10
• Using DriveExecutive on page 3-16
When communication is achieved, the WIM status LED will turn
solid blue.
The NEMA 4 WIM (20-WIM-N4S) is designed for remote installation.
Refer to Figure 2.3
for overall WIM dimensions. Choose an appropriate
location to mount the NEMA 4 WIM. The distance between the WIM
and drive can be increased up to 100 m (328 ft.) by using 1202-H*
extension cable(s) or 1202-CBL-KIT-100M cable. A cable distance
greater than 30 m is not CE compliant.
Figure 2.3 NEMA 4 WIM Dimensions
1. Drill the required hole pattern in the panel. See Figure 2.4 for
dimensions.
Installing the NEMA 4 WIM (20-WIM-N4S)
93,0
(3.66)
25,0
(0.98)
3.0 m
mm
(in.)
180,0
(7.08)
1202-H03 = 0.3 m
1202-H10 = 1.0 m
1202-H30 = 3.0 m
Extension Cable
(supplied separately)
or 1202-CBL-KIT-100M
Contains FCC ID: SNT-2XWIMNX
IC: 5450A-2XWIMNX
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received,
including interference that may cause undesired operation