User manual

ManualsBrandsRockwell Automation ManualsComputer equipment22-WIM-N1

Getting Started 1-5

This section is designed to help experienced users quickly start using the

WIM. If you are unsure how to complete a step, refer to the referenced

chapter.

Figure 1.2 NEMA 1 WIM (20-WIM-N1) Installed in a Drive

Figure 1.3 NEMA 1 WIM (20-WIM-N1) Installed in a HIM Bezel (20-HIM-B1)

Quick Start

Step Action Refer to…

1 Review the safety precautions for the WIM. Throughout

this manual

2 Install the WIM.

For the NEMA 1 WIM (20-WIM-N1), remove the HIM from the

drive cradle and replace it with the WIM. To install the WIM in a

remote-mounted HIM bezel (20-HIM-B1), first install the bezel

(see Publication 20HIM-IN001...). Make sure the HIM bezel is

connected to the drive port using the supplied 1203-C30 cable,

and then place the WIM in the bezel cradle.

For the NEMA 4 WIM (20-WIM-N4S), see Installing the NEMA 4

WIM (20-WIM-N4S) on page 2-3 for installation instructions.

Chapter

Installing the

WIM

3 Configure the WIM parameters.

The WIM is provided ready for use. It is only necessary to

configure the WIM if you want to:

• Change the default setting (0 = Fault) for a Communication

Fault Action using:

– Parameter 02 - [Comm Flt Action] for DPI drives

– Parameter 04 - [Comm Flt Action] for SCANport drives

• Enable the WIM security mode using:

– Parameters 03 - [Security Mode] and 04 - [Security PIN]

for DPI drives

– Parameters 02 - [Security Mode] and 03 - [Security PIN]

for SCANport drives

Chapter 3,

Configuring the

WIM

Pocket PC,

Laptop or Desktop

Computer

PowerFlex 70/700 Drive

with Installed WIM

Contains FCC ID: SNT-2XWIMNX

IC: 5450A-2XWIMNX

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

1) this device may not cause harmful interference, and

2) this device must accept any interference received,

including interference that may cause undesired operation

PowerFlex 70/700 Drives

(with 20-COMM-* Adapter)

Network (DeviceNet, ControlNet, etc.)

HIM Bezel with

Installed WIM