Owner's manual

Getting Started 1-5
This section is designed to help experienced users quickly start using the
serial converter module. If you are unsure how to complete a step, refer
to the referenced chapter.
Figure 1.2 Example Serial Connection to a Personal Computer
Figure 1.3 Example Serial Connection to a Hand-Held Computer
Quick Start
Step Action Refer to
1 Review the safety precautions for the serial converter
module.
Throughout This
Manual
2 Install the serial converter module.
Connect a 22-RJ45CBL-C20 cable to the serial converter
module and the DSI drive. Then, connect a 1203-SFC serial
cable to the serial converter module and a computer. Make
sure that power has been applied to the DSI drive.
Chapter 2
,
Installing the
Serial Converter
Module
3 Configure the serial converter module for your
application.
Use one of the following to configure parameters in the serial
converter module:
• DriveExplorer (v3.01 or higher)
• DriveTools 2000 (v1.01 or higher)
• Terminal emulation software
• VT-100 compatible terminal
Chapter
3,
Configuring the
Serial Converter
Module
DSI Host
22-RJ45CBL-C20
Cable
1203-SFC
Cable
Computer
Serial
Converter
DSI Host
Serial
Converter
Hand-Held
Computer
22-RJ45CBL-C20
Cable
1203-SFC
Cable
Serial
Cable
1203-SNM
Null Cable
Converter
(sold separately)