User Manual

3-2 Configuring the Adapter
The PowerFlex 4-Class HIM (Human Interface Module) can be used to
access parameters in the adapter (see basic steps shown below). It is
recommended that you read through the steps for your HIM before
performing the sequence. For additional HIM information, refer to the
HIM Quick Reference card.
Using the HIM
Using the PowerFlex 4-Class HIM
Step Key(s) Example Screens
1. Power up the drive.
Then plug the HIM
into the drive. The
Parameters menu
for the drive
will be
displayed.
2. Press Sel key once
to display the
Device Selected
menu.
3. Press Enter to
display the DSI
Devices menu.
Press Down Arrow
to scroll to
22-COMM-L.
4. Press Enter to select
the LonWorks
adapter. The
Parameters menu
for the adapter
will
be displayed.
5. Press Enter to
access the
parameters. Edit the
adapter parameters
using the same
techniques that you
use to edit drive
parameters.
Parameters
Groups
Linear List
Changed Params
DIAG PA RAM DSEL MEM SEL !
Sel
Device Select
DSI Devices
DIAG PARAM DSEL MEM SEL !
and
DSI Devices
PowerFlex 40
22-COMM-L
Parameters
Linear List
Changed Params
DIAG PA R AM DSEL MEM SEL !
Send Service Pin RO
Parameter: #
001
Ready 0
VAL UE LIMITS SEL !