Manual

Rockwell Automation Publication 750-IN001N-EN-P - April 2014 201

PowerFlex 750-Series AC Drives

Floor Mount Frames 8…10 Drive Assembly Jumper Removal and

Storage

Frame 8…10 drive assemblies use jumper plugs to complete an electrical

connection when installed. Install or remove jumper plugs according to the

recommendations in Ta ble 30

Figure 110 - Frames 8…10 Drive Assembly PE-B Common Mode Jumper Location

Removal and installation the Inverter Power Control Board tray:

• Recommended torque = 1.86 N•m (16.0 lb•in)

• Recommended screwdriver = T20 Hexalobular

ATTENTION: Hazard of equipment damage exists if jumpers are not properly

disconnected or are set differently between drive assemblies. For Frame 8…10 drive

assemblies, secure the disconnected jumper plug in the socket provided and ensure that

all drive assemblies are identically configured.

Disconnected

Connected

AC Input Drive Shown